The 'Driver'-App is starting to become obsolete: 'sequencial views' switch: For cabinets like Indy 500 (or even Sega Rally) with less than 4 view buttons.īecause of 'Daytona USB' the software side is getting smaller (and simpler) - No more need for a virtual joystick driver - Just plug in the USB cord and you're done. 'sequencial shifter' switch: For cabinets like Indy 500, to shift up and down in Daytona 'alternate axis layout' switch: For cabinets like WingWar it would be better to use X (A0), Y (A1), Z (A2) and RZ (fix value), as many 'non arcade' flight simulators have trouble mapping axis correctly. Currently implemented is a 'Shifter Decoder' Toggle - If turned ON, the SHIFT inputs (Buttons 9-11) are always off, and the shifter gets decoded to the individual gears (Button 12-16) I plan to add some 'dip switch' style options (initial values on hardware, overridable via software). Mapping for Button 9-16 will most likely change in the future, as there is no actual need to have both SHIFT- and GEAR- Inputs - And we are currently missing the 'special inputs' (EX.START, EMERGENCY, COURSE0, COURSE1). = 17-24 -> future use (like RX port on the I/O-Board) = 9-16 -> SHIFT0, SHIFT1, SHIFT2, GEAR1, GEAR2, GEAR3, GEAR4, NEUTRAL

= 1-8 -> VR1, VR2, VR3, VR4, START, SERVICE, TEST, COIN * 4 axis = X (A0 - Wheel), Y (fixed value), Z (A1 - Gas), Z-Rot (A2 - Brake) I've tinkered around with the arduino part, and most likely will replace them with teensy2++ sooner or later.įor the time being I developed a new firmware for the MEGAs that works as plain usb gamepad (like unojoy does) - it features only the controls provided by the daytona (4* axis with full 10bit resolution, 24* buttons) AND is able to receive lamps and drive commands via usb itself. That means I should be able to design an 'interface' board that can be put into any Sega Model-X Racer.Īlso someone noted that the 'newer' Sega Racers might work too, although with some slight modifications (MIDI and/or RS-442 serial instead of 8bit parallel) I need to check the details on the 2B and 2C, most likely they are common to either 2A or 3 Model 2A/3 (although small differences on the button mapping) Model 1/2 (at least Daytona and Virtua Racing seem identical) I checked some wiring diagrams and it seems that there are a few common pinouts: After like a hundred requests for the adapters.

Download daytona usa 2 cabinet